
Goal Design, build, and program an autonomous robot that can search for and push an opposing Sumo robot off an elevated fighting ring.
Goal
Design, build, and program an autonomous robot that can search for and push an opposing Sumo robot off an elevated fighting ring.
Requirements
Autonomous robot, any platform, with a cost of USD $1,500 or less, and compliant with the following design restrictions, which will be verified during robot check-in:
The robot’s maximum size is 25 cm x 18 cm, with no height restriction, measured with any articulated component in its initial position.
Size and mass restrictions are strictly enforced throughout the entire event to ensure fair competition for all participants.
Articulated or moving components are allowed as long as they comply with the design rules above; however, the no intentional damage rule applies. This means fins and sliding plates are okay, but deliberately destructive mechanisms (such as abrasive rotors, hammers, etc.) are not allowed.
LEGO option only: Any LEGO robot may be used, but it must be built entirely from LEGO-brand parts, must be autonomous, and must meet the design specifications.
Competition Ring
The SumoBot challenge ring is a black (or white) circle with a 100 cm diameter, with a 5 cm white border, on a board 13 to 20 mm thick. The ring surface must be elevated 50 to 80 mm above the floor. (Measurements may vary slightly depending on locally available materials.)
ES, MS, HS
If fewer than 5 teams are registered in a division, the Director may combine divisions.
Goal
Design, build, and program an autonomous robot that can search for and push an opposing Sumo robot off an elevated fighting ring.
Divisions / Weight Classes
Refer to the table below to decide which division / weight class you want to compete in.
| Lego Only 1Kg |
| ES |
| MS |
| HS |
| ** |
** These categories may be added at the discretion of the Event Directors.
Note: If fewer than 5 teams are registered in any division, the Event Director has the option to combine divisions.
Requirements
Autonomous robot, any platform, with a cost of USD $1,500 or less, and compliant with the following design restrictions, which will be verified during robot check-in:
Competition Ring
The SumoBot challenge ring is a black (or white) circle with a 100 cm diameter, with a 5 cm white border, on a board 13 to 20 mm thick. The ring surface must be elevated 50 to 80 mm above the floor. (Measurements may vary slightly depending on locally available materials.)
You go straight into Event → Challenge → Division → Team → Registration, without choosing again what you already picked.
1 event(s) with open registration offer SUMOLEGO.